Figure 36: Select A Restored Database To Undo Dialog Box - NorthStar 961 Install Manual

Gps chart navigators

Hide thumbs Also See for 961:

User manual (12 pages)

Reference manual (1 page)

Reference manual (404 pages)

Table Of Contents

Table of Contents

961/962 INSTALLATION MANUAL Revision A

3. Insert the disk into the drive (either a floppy disk or a zip disk), then

press the

(defined as either user preference data, waypoint and route data, or

all data), asking you to wait while the 961/962 restores the data. This

dialog box is followed by the SUMMARY OF DATA RESTORED dialog

box, showing the number of files restored.

4. Press the

screen. To use the restored database, you must restart the 961/

962: Press the

to restart. The 961/962 will now use the restored database.

Undoing a restore

After the 961/962 restores a database, you'll have the option to undo the

restore operation. As long as the 961/962 power is on, you'll always have

this option; however, if you restart the 961/962 by turning it off and

then on, or if power is interrupted, you'll lose the option to undo the

restore.

1. At the DATABASE FUNCTION screen, press the

This key only appears after you've restored a database to the 961/

962, since a database that hasn't been restored can't be undone. The

SELECT A RESTORED DATABASE TO UNDO dialog box appears.

Depending on which database you've just restored, press either the

key. In the sample screen below, only the

key appears.