Using Vga Output - NorthStar 961 Install Manual

Using VGA output

961/962 INSTALLATION MANUAL Revision A
To change the PPNM settings:
1. Press the
PULSE TIME MINIMUM, or PULSE SEPARATION MINIMUM, then press
the key.
2. Enter the desired parameters, then press the
to leave the option unchanged).
The 961/962XD supports an external VGA monitor output from the
female 15-pin standard VGA video connector on the back of the
processor (see Figure 4 on page 23). Conversion of the signal to an NTSC
or PAL video output is possible using VGA converters. Use a
VGA-to-NTSC/PAL converter that doesn't require separate software. This
should be plug-and-play hardware for standard VGA video input
conversion, supporting frame buffering at 75-Hz refresh rate. Also,
consider the requirements for power: A unit requiring a DC power source
is less likely to cause interference.
SECTION THREE - Interfacing
to highlight PULSES PER NAUTICAL MILE,
key (or press
Page 55