Figure 35: Select Database To Restore Dialog Box - NorthStar 961 Install Manual

SECTION FOUR - Service/Maintenance
Page 66
3. Insert the disk into the drive (either a floppy disk or a zip disk), then
press the
(defined as either user preference data, waypoint and route data, or
all data), asking you to wait while the 961/962 saves the data. This
dialog box is followed by the SUMMARY OF DATA SAVED dialog box,
showing the number of files saved.
4. Press the
screen.
Restoring a database
Remember: Restoring a database will overwrite your existing database.
To restore a previously saved database to the 961/962:
1. Press the key until you reach the
press the
2. At the
key. This key only appears after you've saved a
database to the 961/962, since a database that hasn't been saved
can't be restored. The SELECT DATABASE TO RESTORE dialog box
appears.

Figure 35: Select database to restore dialog box

>
To restore only your setup and service options (user preferences),
press the
>
To restore only your waypoints and routes, press the
key (the 961/962 always restores waypoints and
routes together, since routes are comprised of waypoints).
>
To restore all of the above, press the
The RESTORE DATA dialog box appears, defined as either user preference
data, waypoint and route data, or all data, depending on which of the
above options you chose.
key. The SAVING DATA dialog box appears
key to return to the
key.
screen, press the
key.
961/962 INSTALLATION MANUAL Revision A
screen, then
key.