SECTION TWO - Installation
Page 18
.91
1.82
Wiring the AN150 antenna
Supplied with the antenna is a 50-foot length of RG-59 coaxial cable for
use with either the GPS-only AN150 antenna or the GPS/DGPS AN205-P
antenna.
The GPS-only antenna must be used with a minimum of 20
feet of cable and a maximum of 100 feet. Coil up any unused
length; do not cut it to less than 20 feet!
Mounting the AN150 antenna
Tools needed:
•
flat-bladed screwdriver
•
knife blade
•
Amphenol crimp tools
One TNC connector is pre-attached to the antenna end of the RG-59
coaxial cable. To connect it to the antenna:
1. Remove the antenna base by loosening the four captive screws in the
base.
2. Screw the base onto the top of the antenna mount (standard 1"- 14
marine thread).
3. Feed the open end of the supplied coax cable down through the
antenna base and through the hollow core of the antenna mount.
3.00
Figure 6: GPS-only antenna (AN150)
CAUTION!
961/962 INSTALLATION MANUAL Revision A