Program 34 : Tie Line Setup; E&M Tie Line Basic Setup - NEC Electra Elite IPK II Programming Manual

Level:
IN
Description
Use Program 34-01 : E&M Tie Line Basic Setup to defines the basic settings
for each E&M Tie line.
Input Data
Item
Item
No.
01 DID/E&M Start
Signaling
02 --- Not Used ---
03 E&M Dial-In Mode
04 E&M Line Dial Tone
05 System Toll
Restriction
Electra Elite IPK II Programming Manual

Program 34 : Tie Line Setup

34-01 : E&M Tie Line Basic Setup
Trunk Port Number
Input Data
nd
0 = 2 dial tone
1 = Wink
2 = Immediate
3 = Delay
0 = Specify Extension
Number (Intercom)
1 = Use conversion
table (NTT)
0 = Disable (No)
1 = Enable (Yes)
0 = No
1 = Yes
001~200
Default Description
1 Set the start signaling mode for
DID and tie trunks. DID and tie
trunks can use either
immediate start or wink start
signaling.
0 Determine if the incoming Tie
Line call should be directed as
an intercom call or if it should
follow the DID Translation
Table in Program 22-11.
1 Enter 1 if the Tie Line should
send dial tone to the calling
system once the call is set up.
Enter 0 if the Tie Line should
not send dial tone.
0 Determine if an incoming Tie
Line call should be subject to
Toll Restriction.
P r o g r a m
34
Related
Program
22-02
22-11
2 - 325