Vrs/Disa One-Digit Code Attendant Setup - NEC Electra Elite IPK II Programming Manual

Document Revision 1
Level:
IN
Description
Use Program 25-06 : VRS/DISA One-Digit Code Attendant Setup to set up single
digit dialing through the VRS. This gives VRS callers single key access to extensions,
the company operator, Department Calling Groups and Voice Mail. For each VRS
message set to answer outside calls (refer to Program 25-04 and 25-05), you specify:
J
J
The destination can be an extension, a Department Calling pilot number or the Voice
Mail master number. A one-digit code can be assigned for each Automated Attendant
message.
Example:
Message Number=01, Destination=2, Next Message Number=0, Dial=399
In this example, when "2" is dialed by an outside caller, the system transfers the call to
"399". This means that extension 200~299 cannot receive calls from VRS/DISA users
during/after VRS Message 01.
Input Data
2 - 270

25-06 : VRS/DISA One-Digit Code Attendant Setup

The digit the VRS caller dials (0-9,
destinations to digits, outside callers will not be able to dial system extensions.
The destination reached (eight digits max.) when the caller dials the specified digit.
Attendant Message Number
Received Dial
Item
No.
01 Next Attendant Message
Number
02 Destination Number
Program 25 : DID/DISA Setup
, #). (Keep in mind that if you assign
,
Item
0-48 (0 = No Setting)
Up to 8 digits
Electra Elite IPK II
01~48
1-9,0, , #
,
Input Data Default
No Setting
Program 25 : DID/DISA Setup
0