Selectable Display Messages - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Level:
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display
Messages. There are 20 alphanumeric messages, up to 24 characters long. Use the
following chart when programming messages.
Use this keypad
Electra Elite IPK II Programming Manual
Program 20 : System Option Setup
digit . . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, d-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! "
Enter characters:
,
+
,
# # = Accepts an entry (only required if two letters on the same key are
needed - ex: TOM). Pressing # again = Space. (In system programming
mode, use the right arrow soft key instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.

20-16 : Selectable Display Messages

When you want to. . .
→ ←
# $ % & '
, - . / : ; <
Document Revision 1
Á À Â Ã Ç É Ê ì ó
( ) ô Õ ú ä ö ü
σ
= > ?
B E
α ε θ
∞
¢ £
S
2 - 181