Analog Trunk Data Setup - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Level:
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each
analog trunk port. Refer to the chart below for a description of each option, its range
and default setting.
Input Data
Item
No.
01
02
03
04
05
06
Electra Elite IPK II Programming Manual
Program 14 : Trunk, Basic Setup
Trunk Port Number
Item
Signaling Type (DP/DTMF)
This option sets the signaling type for
the trunk.
Ring Detect Type
This option sets Extended Ring Detect
or Immediate Ring Detect for the trunk.
For T1 loop/ground start trunks, this
option must be set to '1' in order for the
trunks to ring and lamp correctly.
Flash Type
This option to select the flash type
(open loop flash or ground). Always set
this option for open loop flash.
Hooking Type
This option lets you use Flash for
Timed Flash (Program 81-01-14) or
Disconnect (Program 81-01-15). (A
user implements Flash by pressing the
FLASH key while on a trunk call.)
Dial Tone Detection for Manual
Accessed Trunks
Use this option enable/disable dial tone
detection for directly accessed trunks.
If disabled, the system outdials on the
trunks without monitoring for dial tone.
Pause at 1st Digit after Line Seize in
Manual Dial Mode

14-02 : Analog Trunk Data Setup

Input Data
0 = Dial Pulse (10 PPS)
1 = Dial Pulse (20 PPS)
2 = DTMF
0 = Normal/delayed
1 = Immediate Ringing
0 = Open Loop Flash
1 = Ground
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used
0 = No Pause (No)
1 = Pause (Yes)
Document Revision 1
001~200
Related
Default
Program
2
1
0
0 81-10-07
81-10-08
21-01-04
1 21-01-06
2 - 91