Fuel Line Removal / Installation; Fuel Tank Removal - Polaris RZR XP 1000 2014 Service Manual

FUEL LINE REMOVAL / INSTALLATION

1. Place a shop towel around the fuel line to catch any
dripping fuel.
2. If removing either end of supply line
tabs while moving green connector out to release the
line.
3. Pull on the fuel line for removal.
4. To install the line, verify the connections are clean
and free of debris.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
5. Place the fuel line back over the fitting and slide the
green connector locking mechanism back into place.
Verify the connector tabs snap back into place.
6. Be sure fuel line is routed and retained properly.

FUEL TANK REMOVAL

Syphon as much fuel from the tank as possible before
attempting to remove it from the vehicle.
Always wear safety goggles when working with high
pressure or flammable fluids. Failure to do so could
result in serious injury or complications.
1. Remove the driver and passenger seats.
w
, pull open
2. Disconnect the negative and positive battery cables
from the battery, located under the driver's seat.
Remove the bolt retaining the battery bracket and
remove the battery from the vehicle.
3. While holding a shop towel over the fuel line
connectors, disconnect the fuel supply line
the pump (see Chapter 2 – Fuel Lines, page 2.20 for
specific removal procedure).
A small amount of fuel may come out of the fuel lines or
pump fitting. Properly drain fuel into a suitable
4. Disconnect the fuel pump electrical harness
FUEL SYSTEM
NOTE
WARNING
q
from
NOTE
container.
w
.
4.17
4