Drive Shaft Boot Inspection; Wheel And Hub Torque Table; Wheel Removal - Polaris RZR XP 1000 2014 Service Manual

MAINTENANCE

DRIVE SHAFT BOOT INSPECTION

Inspect the front and rear drive shaft boots
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced.
Check to see the boot clamps
Refer to DRIVE SHAFT
REPLACEMENT , page
replacement.
2.24
q
for
w
are properly positioned.
CV JOINT / BOOT
for drive shaft boot

WHEEL AND HUB TORQUE TABLE

ITEM
Wheel Nuts
(Cast Aluminum Wheels)
Hub Retaining Nuts
(Front and Rear)
Beadlock Screws
Do not lubricate the stud or the lug nut.

WHEEL REMOVAL

1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.
3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the wheel cap, cotter pin and
loosen the hub nut slightly.
4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
SPECIFICATION
120 ft-lbs (163 Nm)
110 ft-lbs (149 Nm)
Step 1: 24 in-lbs (3 Nm)
Step 2: 7 ft-lbs (10 Nm)
NOTE
© Copyright Polaris Industries Inc.