Table of Contents
Advertisement
EFI / FUEL SYSTEM
FUEL LINE REMOVAL / INSTALLATION
(EVAP)
q
Fuel Supply Line
w
Fuel Purge Line
e
Retaining Clips (attached to fuel pressure regulator
bracket)
1. Place a shop towel around the fuel line to catch any
dripping fuel.
q
2. To remove fuel line
the clip out to release the line.
5.14
, pull open tabs while moving
r
Zip Tie (attached to fuel purge line)
t
Double Clip (attached to frame)
3. Release the fuel line from applicable retaining clips/
zip ties. See image/table above.
4. Remove fuel line from the vehicle.
5. To install the line, verify the connectors are clean and
free of debris.
6. Place the fuel line back over the fitting and slide
connector locking mechanism back into place. Verify
connector tabs snap back into place.
7. Turn the key on to prime the system. Check for
leaking at each end of the fuel line.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
