Polaris RZR XP 1000 2014 Service Manual page 312

FINAL DRIVE
6. Remove the two brake caliper mounting bolts
Remove the rear brake caliper assembly.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
7. Remove the rear wheel hub and brake disk
assembly.
8. Remove the five remaining bolts
rear bearing carrier to the trailing arm. Discard the
nuts.
7.8
t
. 9. Remove the bearing carrier from the rear drive shaft
10. Rotate bearing by hand and check for smooth
Due to extremely close tolerances and minimal wear,
y
that attach the
spots, discoloration, or corrosion. The bearings should
11. Replace bearing if moisture, dirt, corrosion, or
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
and trailing arm.
rotation. Visually inspect bearing for moisture, dirt, or
corrosion.
NOTE
the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
turn smoothly and quietly, with no detectable up and
down movement and minimal movement sideways
between inner and outer race.
roughness is evident.
© Copyright Polaris Industries Inc.