All Wheel Drive Coil; Operation Overview; Diagnosing System Failures - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

ALL WHEEL DRIVE COIL

• When the key switch is "ON", 12 VDC power is present

at the hub coil.

• When the AWD switch is "ON", and if the criteria is

met, the Engine Controller provides a ground path

(brown/white wire). When this occurs the AWD icon

should display in the instrument cluster.

• The AWD system must be grounded to operate.

• Verify the AWD switch is functional and that a

minimum of 11 volts is present at the hub coil.

• Verify the AWD hub coil is functional. Test the AWD

hub coil using an ohm meter. See specifications below:

AWD Hub Coil Resistance:

• Verify the wiring harness, wiring, connectors,

connector pins and grounds are undamaged, clean

and connect properly.

• Verify continuity of wire connections with a known

good volt/ohm meter.

Verify all wires and wiring connections have been

tested properly with a known good volt/ohm meter

before suspecting a component failure. 80% of all

electrical issues are caused by bad/failed connections

and grounds.

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

Table of Contents