Front Prop Shaft Installation; Rear Prop Shaft Removal - Polaris RZR XP 1000 2014 Service Manual

FINAL DRIVE

FRONT PROP SHAFT INSTALLATION

1. Reverse the appropriate Front Propshaft Removal,
page 7.27 procedure to reinstall the front propshaft.
2. Lubricate front gearcase shaft splines with Anti-
Seize.
3. Lubricate the front and rear prop shaft mid joint with
Polaris All Purpose Grease.
4. Align the front and rear prop shafts as shown below
and slide them together.
Paint marks are applied to the front and rear prop shafts
to aid shaft alignment. Reference these marks during
installation if still visible.
5. When installing the front prop shaft onto the front
gearcase, use a new roll pin.
6. Reposition the front gearcase and install the four
bolts that secure the front gearcase to the frame.
Torque bolts to specification.
TORQUE
Front Gearcase Mounting Bolts:
30 ft-lbs (41 Nm)
7.28
NOTE

REAR PROP SHAFT REMOVAL

1. Remove the center console.
q
Cap
w
Shifter
2. Remove the two fasteners
y
bearing cover to the frame.
3. While moving the prop shaft support bearing
assembly, slide the rear prop shaft towards the rear
until the front prop shaft yoke disengages from the
splines.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
e
Torx Screw
r
Push Rivet
t
retaining the support
© Copyright Polaris Industries Inc.