Fuel Line Removal / Installation; Fuel Tank Removal - Polaris RZR 900 2017 Service Manual

Hide thumbs Also See for RZR 900 2017:

Table of Contents

FUEL LINE REMOVAL / INSTALLATION

1. Place a shop towel around the fuel line

any dripping fuel.

2. If removing either end of the supply line

tabs while moving the green connector out to release

3. Pull on the fuel line to remove.

4. To install, verify the connections are clean and

9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual

5. Place the fuel line back over the fitting and slide the

green connector locking mechanism back into place.

Verify the connector tabs snap back into place.

6. Be sure the fuel line is routed and retained properly

and lightly tug on the fuel line to ensure it is fastened.

Syphon as much fuel from the tank as possible before

attempting to remove it from the vehicle.

Always wear safety goggles when working with high

pressure or flammable fluids. Failure to do so could

result in serious injury or complications.

1. Remove the driver and passenger seats.

2. Disconnect the negative and positive battery cables

from the battery, located under the driver's seat.

Remove the bolt retaining the battery bracket and

remove the battery from the vehicle.

3. On S 1000 models only, remove the fuel pump close

off panel by pinching in the tabs and pulling up.

Table of Contents