Throttle Body Removal - Polaris RZR XP 1000 2014 Service Manual

FUEL SYSTEM

THROTTLE BODY REMOVAL

1. Remove the cargo box assembly (See Chapter 10 –
Cargo Box Assembly Removal, page 10.22).
2. Be sure the engine has cooled enough to work on.
3. Loosen the hose clamps
w
plenum to the throttle body.
4. Remove the two screws
plenum.
5. Remove the driver's seat and disconnect the
negative battery cable.
4.34
q
retaining the intake
e
retaining the intake
6. Disconnect the wire harness from the ETC
t
the TMAP located on the ends of the throttle body
assembly.
7. Loosen the two hose clamps
throttle body assembly
Carefully lift the throttle body assembly out of the
intake adapters.
8. Remove the two screw retaining the fuel rail to the
throttle body. Lift the fuel rail and injectors out of the
throttle body assembly taking care not to damage the
fuel injector ends.
It is not necessary to disconnect fuel lines or the injector
harnesses to perform this procedure.
9. Reverse the previous steps to reinstall the throttle
body.
10. Upon installation of the fuel rail and injectors, lightly
lubricate injector O-rings to aid installation. Torque
the fuel rail mounting screws to specification.
TORQUE
Fuel Rail Mounting Screws:
44 in-lb (5 Nm)
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
y
that retain the dual
u
to the intake adapters.
NOTE
© Copyright Polaris Industries Inc.
r
and