Setup - Toro Reelmaster 03781 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Operator training material
Declaration of Conformity
Note: Determine the left and right sides of the machine from the normal operating position.
Description
No parts required
Warning decal
Hood-lock bracket
Rivet
Screw (1/4 x 2 inch)
Flat washer (1/4 inch)
Locknut (1/4 inch)
Front hose guide (right)
Front hose guide (left)
No parts required
Cutting-unit kickstand
No parts required
No parts required
Gauge bar
Qty.
–
1
1
2
1
2
1
1
1
–
1
–
–
1
Qty.
1 Read the manual before operating the machine.
1 Read the manual before operating the engine.
1 View the training material before operating the machine.
1 This document indicates CE compliance.
10
Use
Adjust the support rollers.
Replace the decal for CE Compliance.
Install the hood lock for European CE
Compliance.
Install the cutting units.
Adjust the turf-compensation spring.
Use the cutting-unit kickstand.
Grease the machine.
Check the levels of the rear axle
lubricant, hydraulic fluid, and engine oil.
Use the gauge bar to adjust the cutting
unit.
Use