Figure 12
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1
1. Hose guides (each must lean toward the center cutting unit)
Note: When installing or removing the cutting
units, make sure that the hairpin cotter is installed
in the spring-rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
7. Increase the steering on the rear cutting units by
removing the 2 pivot spacers, hex-socket screws, and
flange locknuts
(Figure
the rear cutting units (Cutting Units 2 and 3); refer to
Figure
12.
5. Cutting unit 5
6. Reel motor
7. Weight
15) from the carrier frames of
g031275
1. Hose guide (left side
shown)
2. Rod bracket
Figure 14
14
Figure 13
3. Nuts
1
g015160
g019602
g019602