Toro Reelmaster 03781 Operator's Manual page 22

InfoCenter Icon Description
SERVICE DUE Indicates when scheduled service
should be performed
Info icon
Hour Meter
Fast
Slow
Fan reversal—indicates when the fan
is reversed
Air intake heater is active
Raise cutting units
Lower cutting units
Operator must sit in seat
Parking Brake Indicator—indicates
when the parking brake is On
Identifies the range as High
Neutral
Identifies the range as Low
Coolant Temperature-indicates the
engine coolant temperature in either
°C or °F
Temperature (hot)
Denied or not allowed
PTO is engaged
Engine Start
Stop or shutdown
Engine
Key switch
InfoCenter Icon Description (cont'd.)
/
Symbols are often
combined to form
sentences. Some
examples are shown
below.
22
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic Oil Temperature-indicates
the hydraulic oil temperature
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
High: over allowed range
Low: under allowed range
Out of range
Switch
Operator must release switch
Operator should change to indicated
state
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
Hydraulic oil too hot
Sit down or set parking brake