Installing The Cutting Units - Toro Reelmaster 03781 Operator's Manual

9. Tighten the bolt securely but do not tighten the nut.
4

Installing the Cutting Units

Parts needed for this procedure:
1 Front hose guide (right)
1 Front hose guide (left)
Procedure
1. Remove the reel motors from the shipping brackets.
2. Remove and discard the shipping brackets.
3. Remove the cutting units from the cartons.
4. Assemble and adjust as described in the cutting unit
Operator's Manual.
5. Make sure that the counter weight
to the proper end of the cutting unit as described in the
cutting unit Operator's Manual.
1. Counter weight
6. All of the cutting units are shipped with the turf
compensation spring mounted to the right side of the
cutting unit. The turf compensation spring must be
mounted to the same side of the cutting unit as the
reel drive motor. Reposition the turf compensation
as follows:
A. Remove the 2 carriage bolts and nuts securing the
rod bracket to the cutting-unit tabs
(Figure 9) is installed
Figure 9
(Figure
1. Turf compensation spring
2. Rod bracket
B. Remove the flange nut securing the spring-tube
bolt to the carrier-frame tab
C. Remove the assembly.
D. Mount the spring-tube bolt to the opposite tab on
the carrier frame and secure with the flange nut.
Note: Position the bolt head to the outer side of
the tab as shown in
1. Opposite carrier frame tab
E. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts
the cutting unit, mount the left hose guide to the
front of the cutting unit tabs when reinstalling the
rod bracket
Important: On Cutting Unit 4 (left front)
and Cutting Unit 5 (right front), use the
rod-bracket mounting nuts to install the hose
guides to the front of the cutting-unit tabs.
The hose guides should lean toward the center
cutting unit
g003320
10).
13
Figure 10
3. Spring tube
(Figure 10)
Figure 11.
Figure 11
2. Rod bracket
(Figure
(Figure 13).
(Figure 12 through Figure
g003949
g003967
11). On
14).