Hitachi HF-W2000 58 Instruction Manual page 53

1. GETTING STARTED
Name
LAN port
(1000BASE-T/100BASE-TX/
10BASE-T)
Note 1: The locations of the ACT/LINK lamp and the communication speed lamp differ between the optional LAN
adapter and the onboard LAN.
Note 2: HJ-F2050-20 has two LAN ports. Looking from the back side of this equipment in a horizontal installation,
the port A is on your left and the port B is on your right.
Table 1-1 Function of each part (4/5)
Optional LAN adapter (HJ-F2050-20)
Lamp
Lit in green A link is established. Both the equipment and the remote
device are powered up and the connection over the twisted-
pair Ethernet cable is stable.
Off No link is established:
• The equipment is not physically connected to the network.
• The switching hub is not powered up.
• The connection over the twisted-pair Ethernet cable is not
stable.
• The driver settings contain one or more errors.
Blinking Network data is being transmitted or received. The blink
green interval changes depending on network traffic.
Communication speed lamp
Lamp
Lit in orange The link is established at 1000 Mbps.
Lit in green The link is established at 100 Mbps.
Off The link is established at 10 Mbps, or no link is established.
Left
Right
(port A) (port B)
1-10
Function
ACT/LINK lamp
Communication speed lamp
ACT/LINK lamp
Status
Status
Slot 3 (HJ-F2050-20 cannot be installed)
Slot 2 (HJ-F2050-20 can be installed)
Slot 1 (HJ-F2050-20 can be installed)