Hitachi HF-W2000 58 Instruction Manual page 22

SAFETY INSTRUCTIONS (Continued)
• Wear cotton gloves when replacing an HDD to prevent problems caused by static electricity. Not
doing so might result in corruption of the data stored on the HDD.
• Verify correct procedures before starting work. Failure to follow the correct procedures might result
in data stored on an HDD being lost.
• Wear cotton gloves when replacing an HDD to prevent problems caused by static electricity. Not
doing so might result in corruption of the data stored on the HDD.
• Verify correct procedures before starting work. Failure to follow the correct procedures might result
in data stored on an HDD being lost.
• Do not use an HDD previously used in any model as a replacement HDD. If you do, this equipment
might not operate properly or the data on the HDDs might be lost because of configuration
information mismatches or other reasons.
• Do not replace two HDDs at the same time. Doing so might result in data corruption.
• When replacing an HDD, set the HDD to offline mode in the Hardware status window, and then
remove the HDD and install the replacement HDD. Installing or removing an HDD when the
hardware status is not verifiable, for example, immediately after the OS starts, might result in a
failure.
• Do not use a replaceable component for longer than the recommended replacement cycle. If you do,
a deteriorating or worn-out component might cause the equipment to fail.
S-17
(Page 10-21) (Page 10-22)
(Page 10-23)
(Page A-1)