Hitachi HF-W2000 58 Instruction Manual page 16

SAFETY INSTRUCTIONS (Continued)
• Before moving this equipment, shutdown the OS, unplug the power cord, and wait for at least one
minute. Not doing so might cause HDDs, SSDs, and other devices to fail.
• When transporting or carrying the equipment, pack it by using the dedicated container (the
container and packing materials used when the equipment was delivered). Using another container
or other packing materials might damage the equipment.
• Do not use the dedicated container to transport or carry the equipment if the container has been
damaged or broken. Doing so might damage the equipment.
• Do not route interface cables and other cables (including cables for other devices, such as a PC)
near the power cord. Doing so might cause a failure or malfunction in the equipment.
• Do not connect or disconnect an interface cable while the power for this equipment or for a remote
device is on. If you do so, a short circuit between the power supply and the ground might cause a
failure in the equipment. If an interface cable comes off while the power for the equipment is on,
shutdown the OS and unplug the power cord. Unplugging the power cord without shutting down the
OS might destroy internal files.
• When you connect a cable for external contacts, connect the cable to a connector for the external
contacts (EXT). A voltage as high as 40 V DC might be applied to the cable through a relay load. If
you connect the cable to the wrong connector, this might cause a failure in the equipment.
• Performing an emergency shutdown (that is, unplugging the power cord or shutting off the circuit
breaker without properly shutting down the OS) might cause the OS or applications not to work
properly or might cause saved data to be corrupted. Never perform an emergency shutdown unless
some kind of error requires that you stop the system immediately.
• Note that if the power supply is cut, the system might not be able to recover automatically.
S-11
(Page 1-13)
(Page 1-16)
(Page 2-4)