Removing And Installing The Lithium Battery; Figure 6-12(1) Removing The Lithium Battery - Hitachi HF-W2000 58 Instruction Manual

6. INSPECTION AND MAINTENANCE

6.4 Removing and installing the lithium battery

● This equipment uses a lithium battery. When replacing the lithium battery, use a battery
specified by the manufacturer. Failure to do so might result in an explosion, a fire, a burst
battery, heat generation, a liquid spill, or gas generation.
● Install the battery by using the correct polarity. Using the wrong polarity might cause an
abnormal reaction, such as charging or shorting, resulting in a liquid spill, heat generation,
or a burst battery.
(1) Before removing the lithium battery
•
Before starting work, see 6.3.2 Before installing or removing components.
(2) Removing and installing the lithium battery
[1] Follow the instructions in 6.3.3 Installing and removing the cover of the main unit to remove the cover of the
main unit.
[2] If the connection connector (DCIN2) is interfering with your ability to remove the lithium battery, remove the
connection connector before removing the lithium battery.
[3] Pick up both ends of the battery cover with your thumb and forefinger, and lift one end of the battery cover.
Lithium battery
[3] Hold with thumb
and forefinger
Connector
CAUTION
Battery cover
[3] Lift up on the end of
the battery cover

Figure 6-12(1) Removing the lithium battery

6-20
Connection connector (DCIN2)