Table of Contents
Advertisement
8. MAINTENANCE OPERATIONS
(2) Specifying a memory dump file
1. Open the Start menu, and then click Control Panel and System and Security. Then, click System.
2. Under Task on the left side of the window, click Advanced system settings.
3. In the Advanced tab, under Startup and Recovery, click Settings.
4. In the Dump file box, enter a memory dump file name.
By default, %SystemRoot%\MEMORY.DMP is specified.
If no changes are required, you do not need to enter another name in this box.
5. Select the Overwrite any existing file check box.
6. Click OK.
To enable the Complete memory dump setting that is recommended for this equipment, perform the procedure
below:
1. In the C:\Program Files\HFWRAS\init folder, double-click the SetCrashDump.reg file.
2. The following message box appears. Click Yes.
3. A message box appears, indicating that information has been added successfully. Click OK.
4. The setting is applied after the system restarts.
(3) Reserve the area for saving a memory dump
Reserve the area to be used for saving a memory dump by using the createdmp command.
For details, see 8.4 Maintenance Operation Commands.
8-10
Advertisement
Table of Contents
