Yamaha T8 Rigging Manual page 416

Outboard Rigging Guide - 2001
3. Insert the upper support bolt through the
tubes located directly under the cavitation
supports of the left and right-hand main sup-
ports. Place one nut onto the bolt and tighten.
T ightening T orque:
1.1m-kg ( 8.0ft-lb.)
CAUTION:
D o not over-tighten. O utboard or display stand
could be damaged.
4. Insert the lower skeg support pinch bolt
through the rear hole of the skeg plate. Place
one hex nut onto the bolt and tighten.
CAUTION:
D o not over-tighten. T he outboard or stand
could be damaged.
WARNING
A n outboard motor on a display stand can be
bumped over, causing injury or damage. L ag-
bolt the display stand to the floor through the
two pre-drilled holed in the stand base.
D o not modify the display stand. M odification
could make the display stand unsafe to use or
could damage the outboard motor.
9-8
Outboard Display Stands