Yamaha T8 Rigging Manual page 32

Outboard Rigging Guide - 2001
Mid Size Model(s) 40, C40, F40, 50, C50, F50, T50, 60, C60, 70, C70, F80, 90, C90, F100,
F115
Remote Models
Rigging for Standard Side Mount 703 Control Box
Control Cables (2 req.)
Control Box PT & T
(New Switch Main Switch and Safety Lanyard / Push To Open Throttle) OPT
Optional Extension Harness for 10 Pin Main Harness
(Use as needed)
Installing Engine with 704 Single Binnacle or 705 Flush Mount Control Box
Single Binnacle (1 Req.)
or
Flush Mount (1 Req.)
Switch Panel Assembly (1 Req.)
Main Harness - 10 Pin (1 Req.)
Optional Extension Harness 10 Pin Main Harness
(Use as needed)
Engine to Tach Harness
No Four Stroke Engines
Engine to Tach Harness, Trim & Oil Harness
Models with Oil Injection and Low Oil Warnings on
Four Stroke Engines
1
NOTE Order control cables using part number ABA-CABLE-XX-GY substituting the correct footage
needed in place of the XX. Yamaha control cables in 1 ft. increments from 6~30 ft. and in 2 ft.
increments from 32~50 ft.
2
NOTE If a longer harness is required, you have two choices. Order from the available harnesses, the
length needed, or order additional length trim harnesses to connect to the standard harness (two trim
harnesses will extend one 64D harness). This applies to the oil lamp, trim and oil tank harnesses from 70~250
models.
2 Non-Oil Injected Engines
(OPT 1 Req.)
2
6.6 ft. OPT
9.8 ft. OPT
16.4 ft. OPT
26 ft. OPT
6.6 ft. OPT
9.8 ft. OPT
9.8 ft. OPT
16.4 ft. OPT
22.9 ft. OPT
26.2 ft. OPT
31.2 ft. OPT
9.8 ft. OPT
16.4 ft. OPT
Single Gauge Kit - 23.0 ft. STD
26.2 ft. OPT
Dual Gauge Kit - 31.2 ft. STD
xxiii
Quick Start
ABA-CABLE-XX-GY
703-48207-15-00
688-8258A-10-00
688-8258A-30-00
704-48205-13-00
6X0-48206-11-00
704-82570-05-00
688-8258A-50-00
6K1-8258A-40-00
688-8258A-10-00
688-8258A-30-00
6R3-82553-30-00
6R3-82553-50-00
6R3-82553-70-00
6R3-82553-80-00
6R3-82553-90-00
64D-82553-30-00
64D-82553-50-00
64D-82553-70-00
64D-82553-80-00
64D-82553-90-00