Yamaha T8 Rigging Manual page 368

Outboard Rigging Guide - 2001
3. Adjust:
• Shift cable joint position
9
8
18
2 0
8
9
10
A djustment S tep:
• Place the remote control lever of the remote
control box in Neutral Position.
• Place the shift lever
• Install the shift cable a to the remote con-
trol bracket 3.
• Adjust the position of the cable end 8 until
its hole aligns with the set pin of the shift
lever .
20
• Insert the clip 9 from the upside of the set
pin.
WARNING
• T he cable end 8 8 should be screwed in
more than 8mm ( 0.31 in) .
• T he clip 9 9 should be installed from the
up side as shown in the illustration.
8
b
3
8mm ( 0.31 in)
in Neutral position.
20
9.9/15 (2-Stroke) Remote Control Attach. Kit
4. Adjust:
• Throttle cable joint position
A djustment S tep:
• Place the remote control lever of the remote
control box in Neutral Position.
• Install the throttle cable 6 to the remote
control bracket 3.
• Place the throttle control grip to the fully
closed position.
• Adjust the position of the cable end 8 until
its hole aligns with the set pin of the throttle
lever .
18
• Insert the clip 9 from the upside of the set
pin.
WARNING
• T he cable end 8 8 should be screwed in
more than 8mm ( 0.31 in) .
• T he clip 9 9 should be installed from the
up side as shown in the illustration.
7-7