Huawei FusionModule1000A40 Maintenance Manual page 35

FusionModule1000A40 Prefabricated All-in-One
Data Center
Maintenance Guide
Check Item Operation
RF_Z indicator
Door status Open a door
sensor with a status
sensor, and
check the
alarm
information
displayed on
the monitoring
software
terminal.
Issue 04 (2021-02-10)
Check Standard
On: No network
parameters exist. A
network is waiting to
be created.
Blinking slowly: A
network is set up, and
node access is not
allowed (the indicator
blinks at 0.5 Hz, on
for 1s and then off for
1s).
Blinking at super
short intervals: A
network is set up, and
node access is
allowed (the indicator
blinks at 10 Hz, on for
0.05s and then off for
0.05s).
Blinking at super
short intervals
intermittently: The
device is searching for
a network (the
indicator blinks at 2
Hz, on for 0.5s and
then off for 0.5s).
An access alarm is
generated on the
ECC800 WebUI.
Copyright © Huawei Technologies Co., Ltd.
3 Routine Maintenance
Troubleshooting
For details, see the ECC800 documents.
If no alarm is raised when a door with a
status sensor is opened, replace the
door status sensor.
28