Controls - Toro Groundsmaster 7210 Series Operator's Manual

Controls

Become familiar with all the controls before you start
the engine and operate the machine
Figure 4).
Motion-Control Levers
The motion-control levers control the forward and
rearward motions as well as the turning of the
machine. Refer to Driving the Machine (page
Parking-Brake Lever
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
To engage the parking brake, pull the parking-brake
lever rearward and up
parking brake, push the parking-brake lever forward
and down.
1. Parking-brake lever
Ignition Switch
The ignition switch has 3 positions: O
and S .
TART
Throttle Lever
The throttle lever controls the speed of the engine,
the speed of the blades, and, in conjunction with
motion-control levers, the ground speed of the
machine. Moving the throttle lever forward toward the
F position increases the engine speed. Moving
AST
it rearward toward the S
engine speed. Always run the machine with the
throttle in the F position when cutting grass.
AST
(Figure 3
(Figure 5). To release the
Figure 5
, O /P
FF N
position decreases the
LOW
Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
mower blades.
and
Using the InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine such as the operating status, various
diagnostics and other information about the machine
(Figure 6). There is a splash screen and main
23).
information screen of the InfoCenter. You can switch
between the splash screen and main information
screen, at any time, by pressing any of the InfoCenter
buttons and then selecting the appropriate directional
arrow.
1. Indicator light
2. Right button
•
Left Button, Menu Access/Back Button—press this
g020866
button to access the InfoCenter menus. You can
use it to back out of any menu you are currently
using.
•
Middle Button—use this button to scroll down
menus.
•
Right Button—use this button to open a menu
where a right arrow indicates additional content.
,
REHEAT
Note:
The purpose of each button may change
depending on what is required at the time. Each
button is labeled with an icon displaying its current
function.
9
Figure 6
3. Middle button
4. Left button
g020650