Toro Groundsmaster 7210 Series Operator's Manual page 57

Figure 84
1. Bolt
2. Control panel
4. Move the control lever to the N
but not locked (Figure
5. Pull the lever back until the clevis pin (on an
arm above the pivot shaft) contacts the end of
the slot (just beginning to put pressure on the
spring) as shown in
Figure 85
1. Clevis pin
2. Slot
3. Jam nut
6. Check where the control lever is relative to notch
in the console (Figure
Note:
The control lever should be centered,
allowing lever to pivot outward to the
N - position.
EUTRAL LOCK
position
EUTRAL
86).
Figure 85.
4. Adjustment bolt
5. Yoke
86).
g020875
1. N position
EUTRAL
7. If adjustment is needed, loosen the nut and jam
nut against the yoke
8. Applying slight rearward pressure on the
motion-control lever, turn the head of the
adjustment bolt in the appropriate direction until
the control lever is centered in the N
position (Figure
Note:
Rearward pressure on the lever keeps
the pin at the end of the slot and allow the
adjustment bolt to move the lever to the
appropriate position.
9. Tighten the nut and jam nut
10. Repeat steps
lever.
11. Install the front panel.
g004651
57
Figure 86
2. N -
EUTRAL LOCK
(Figure 85).
EUTRAL
85).
(Figure 85).
4 through 9 for the other control
g004918
position
-
LOCK