Adjusting The Height Of Cut - Toro Groundsmaster 7210 Series Operator's Manual

Raising the Roll Bar
Raise the roll bar as shown in
Figure 12
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Figure 11.
g031636
g031631

Adjusting the Height of Cut

You can adjust the height of cut from 2.5 to 15.8 cm
(1 to 6 inches) in 6 mm (1/4 inch) increments by
relocating the stop pin into different hole locations.
1. With the engine running, push the deck-lift
switch up until the mower deck is fully raised and
release the switch immediately
2. Rotate the stop pin until the roll pin in it lines up
with the slots in the holes in the height-of-cut
bracket and remove it
3. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, insert
the pin, and rotate it down to lock it in place
(Figure 13).
Note:
There are 4 rows of hole positions
(Figure 13). The top row gives you the height of
cut listed above the pin. The second row down
gives you the height listed plus 6 mm (1/4 inch).
The third row down gives you the height listed
plus 12 mm (1/2 inch). The bottom row gives you
the height listed plus 18 mm (3/4 inch). For the
15.8 cm (6 inch) position, there is only 1 hole,
located in the second row. This does not add
6 mm (1/4 inch) to the 15.8 cm (6 inch) position.
1. Stop pin
4. Adjust the anti-scalp rollers and skids as
required.
18
(Figure
(Figure 13).
Figure 13
2. Height-of-cut stop
24).
g020870