Engine Maintenance; Engine Safety; Checking The Air Cleaner - Toro Groundsmaster 7210 Series Operator's Manual

4. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
5. Lift the footrest, exposing the top of the mower
deck.
6. Remove the dipstick/fill plug from the top of the
gearbox (Figure 65).
7. Place a funnel and drain pan under the drain
plug located under the front of the gearbox and
remove the plug, draining the lubricant into the
pan.
8. Replace the drain plug.
9. Add enough lubricant, approximately 283 ml (12
fl oz), until the level is between the marks on the
dipstick.
Important:
Do not overfill the gearbox;
overfilling the gearbox may damage it.

Engine Maintenance

position,
LOW

Engine Safety

•
•

Checking the Air Cleaner

Service Interval: Every 400 hours Service it also
1.
2.
3.
1. Air-cleaner cover
2. Gasket
3. Filter
4. Air-cleaner body
4.
46
Shut off the engine and remove the key before
checking the oil or adding oil to the crankcase.
Do not change the governor speed or overspeed
the engine.
when the air-cleaner indicator
shows red; service the air-cleaner
filter more frequently in extremely
dusty or dirty conditions.
Check the air-cleaner body for damage, which
could possibly cause an air leak. Replace a
damaged air-cleaner body.
Check the air-intake system for leaks, damage,
or loose hose clamps.
Service the air-cleaner filter
Important:
Do not over-service the air filter.
Figure 66
Be sure that the cover is seated correctly and
seals with the air-cleaner body.
(Figure 66).
g243914
5. Air-cleaner indicator
6. Air-cleaner latch
7. Rubber outlet valve