Toro Groundsmaster 7210 Series Operator's Manual page 48

Figure 68
1. Dipstick
4. If the oil is below the safe range, remove the
fill cap (Figure 68) and add oil until the level
reaches the Full mark.
Important:
Do not overfill the engine with
oil.
Note:
When using different oil, drain all old oil
from the crankcase before adding new oil.
5. Install the oil-fill cap and dipstick.
6. Close the hood and secure it with the latches.
Crankcase Oil Capacity
5.2 liters (5.5 qt) with the filter.
Changing the Engine Oil and Filter
Service Interval: Every 250 hours
1. Remove the oil-drain plug
the oil flow into a drain pan. When all the oil is
drained, install the drain plug.
g020435
2. Oil-fill cap
(Figure 69) and let
1. Oil-drain plug
2. Remove the oil filter
coat of clean oil to the new filter seal before
screwing it on. Do not overtighten.
3. Add oil to the crankcase; refer to
Engine-Oil Level (page
48
Figure 69
2. Oil filter
(Figure 69). Apply a light
Checking the
47).
g021890