Changing The Hydraulic Fluid And Filter; Cleaning; Cleaning Under The Mower; Waste Disposal - Toro Groundsmaster 7210 Series Operator's Manual

Changing the Hydraulic
Fluid and Filter
Service Interval: After the first 200 hours
Every 800 hours
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Place a large pan under the hydraulic reservoir
and transmission case and remove the plugs,
draining all of the hydraulic fluid
Figure 93
1. Hydraulic-reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic fluid filter
and remove the filter
5. Immediately install a new hydraulic fluid filter.
6. Install the hydraulic-reservoir and
transmission-case drain plugs.
7. Fill the reservoir to the proper level
(approximately 5.7 L or 6 US qt); refer to
Checking the Hydraulic System (page
8. Start the engine and check for oil leaks. Allow
the engine to run for about 5 minutes, then shut
it off.
9. After 2 minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic System
(page 61).
- position, and
LOCK
position,
LOW
(Figure 93).
3. Transmission-case drain
plug
(Figure 93).
61).

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the mower to the transport position.
4. Raise the front of the machine using jack stands.
5. Thoroughly clean the underside of the mower
with water.

Waste Disposal

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants. Dispose of these according to
your state and local regulations.
g004652
62
- position, and
EUTRAL LOCK
position,
LOW