Removing The Feed Motor (M101) - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Feed Motor (M101)

Removing the Feed Motor (M101)

2) Remove the 2 screws and open the finisher controller PCB
1) Remove the rear cover
(upper). mount.
(Refer to page 4-19)
x2
4) Remove the motor connector and the tension spring. Remove
the 2 screws and then remove the feed motor.
4
Parts Replacement and Cleaning Procedure > Motors > Removing the Feed Motor (M101)
3) Release the harness from the harness guide and remove the 2
harness guides.
F-4-163
F-4-165
F-4-164
4-68
4-68