Removing The Swing Guide Open Solenoid (Sl101) - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Swing Guide Open Solenoid (SL101)

Removing the Swing Guide Open Solenoid (SL101)

2) Lower the swing guide and put a mark on the fixed position of the swing open solenoid.
1) Remove the grated-
shaped upper guide.
(Refer to page 4-23)
CAUTION:
When attaching the swing
guide open solenoid
(SL101), check the position
attached the swing guide
unit.
(Refer to page 4-45)
4 Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Swing Guide Open Solenoid (SL101)
3) Release the solenoid harness from the edge saddle, and then remove
the 2 screws to remove the swing open solenoid.
F-4-115
4-49
F-4-116
4-49