Checking The Position Attached The Swing Guide Unit - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Checking the position attached the Swing Guide Unit

Checking the position attached the Swing Guide Unit

1) Raise the swing guide unit while pushing the plunger of the swing guide solenoid, and
then check that the gap between the swing guide upper cover and the arm of the staple
safety switch is within 1.5±0.5mm.
CAUTION:
If the gap is outside the standard, adjust according to the following steps 2) to 3).
When attaching the swing
guide unit, swing guide
upper cover and swing
guide open solenoid
(SL101), check the gap
between the swing guide
upper cover and the arm of
the staple safety switch.
3) Check whether the gap between the swing
guide upper cover and the arm of the staple
safety switch is within 1.5±0.5mm. If the gap is
outside the standard, adjust again.
CAUTION:
If the gap between the
swing guide upper cover
and the arm of the staple
safety switch is outside the
standard, it might defective
movement.
4 Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Checking the position attached the Swing Guide Unit
2) Loosen two screws and shift the position of the swing guide open
solenoid to adjust the position of the staple safety switch's arm.
Then, tighten two screws.
1.5±0.5mm
F-4-104
4-45
F-4-105
4-45