Huawei USG6000 Series Hardware Manual page 74

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Name
Ports
MGMT port
Console port
(RJ45)
USB0 and
USB1 ports
0 to 7 (RJ45)
8 to 11 (SFP)
Indicators
SYS indicator
(green)
ALM indicator
(red)
PWR indicator
(green)
HDD indicator
(green)
MODE indicator
(green)
Issue 03 (2015-01-26)
Description
Out-of-band 10/100/1000M RJ45 autosensing Ethernet management
port. The interface number is GigabitEthernet 0/0/0 and the default IP
address of the interface is 192.168.0.1.
You can connect this port to the network port or any reachable port on a
PC through a network cable. Then, you can use Telnet to access the CLI
or use a web browser to access the web UI to configure, manage, and
maintain the USG.
NOTE
The MGMT port cannot be used as a service port.
Console ports allow you to locally connect to the device. You can use a
console cable to connect the console port (RJ45) on the device to the
COM port on your PC and use a serial port terminal program on your
PC to access, configure, and manage the device.
USB ports allow you to insert USB devices for system software
upgrades. For details on upgrades through USB devices, refer to the
Upgrade Guide delivered with the device.
Service ports. They are eight 10/100/1000M autosensing Ethernet
electrical ports numbered from GigabitEthernet 1/0/0 to
GigabitEthernet 1/0/7.
Service ports. They are four GE optical ports numbered from
GigabitEthernet 1/0/8 to GigabitEthernet 1/0/11. Each port requires a
Gigabit Optical Transceiver.
 Steady on: The system is powering on or restarting.
 Blink every two seconds (0.5 Hz): The system is running normally.
 Blink twice every second (2 Hz): The system is starting.
 Blink eight times every second (8 Hz): The system software or
configuration file is being upgraded.
 Off: The system is faulty.
 Steady on: The system is faulty. For example, the power-on self test
(POST), power voltage, or temperature is abnormal.
 Off: The system is running normally.
 Steady on: The power module works properly.
 Off: The power module is faulty or the power cable is disconnected.
 Steady on: The hard disk is running.
 Blink twice every second (2 Hz): Data is being read from or written
to the hard disk.
 Off: The hard disk is not detected.
 Steady on: Hot standby is not configured, or hot standby is
configured but the device is the standby device in an active/standby
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Hardware Overview
64