Huawei USG6000 Series Hardware Manual page 231

HUAWEI USG6000 Unified Security Gateway
Hardware Guide






Issue 03 (2015-01-26)
The USG provides cord end terminals and OT bare crimp terminals. You can use them
based on the actual condition, including striping the cable, assembling a terminal, and
crimping the cable.
When you remove the insulation of the power cable, ensure that the metal conductor of the power
cable is not damaged.
For the cord end terminals from EdgeWave, you are advised to set L1 to 10 mm. For the cord end
terminals from vendors other than EdgeWave, you are advised to adjust the value of L1 based on the
value of L, that is, L1 = L + 1 mm.
For the OT bare crimp terminals from EdgeWave, you are advised to set L1 to 7 mm. For the OT
bare crimp terminals from vendors other than EdgeWave, you are advised to adjust the value of L1
based on the value of L, that is, L1 = L + (1 to 2) mm.
Assembling cord end terminals and OT bare crimp terminals requires crimping tools. The shapes of
the crimped terminals vary with crimping molds. Select a proper crimping mold.
If the power supply device requires to connect to a cord end terminal, see
assemble the terminal.
Figure 2-49 Assembling the cord end terminal to the DC power cable
If the power supply device requires to connect to an OT bare crimp terminal, see
2-50 to assemble the terminal.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
Figure 2-49 to
Figure
221