Huawei USG6000 Series Hardware Manual page 178

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Ensure that the mounting screws are secure and reliable. Otherwise, the tension after cables
are connected may cause the USG6310/6320 to fall.
1.
2.
3.
Step 3 Mount a USG on the wall by aligning the mounting brackets on the rear of the USG with the
mounting screws.
The USG supports upward mounting and downward mounting. To prevent water from entering into
ports and causing device damage, you are advised to mount the USG with ports facing downward.
Issue 03 (2015-01-26)
Select a proper drill according to the outer diameter of mounting screws. The outer
diameter of mounting screws is not greater than 4 mm.
Hammer hollow wall anchors into the mounting holes.
Screw the mounting screws into the wall anchors using a Phillips screwdriver. Leave the
screws protruding 2 mm from the wall.
Figure 2-8 Drilling holes and installing mounting screws
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
168