Huawei USG6000 Series Hardware Manual page 227

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Figure 2-46 Installing optical transceivers and connecting optical fibers
Step 5 Repeat
----End
Follow-up Procedure
After you power on the USG, check the connection by observing the optical port indicator. If
the indicator is on or blinks, the link is connected or data is being transmitted. If the indicator
is off, the link is disconnected. Possible causes for the disconnection are as follows:
Issue 03 (2015-01-26)
Step 1 to Step 4 to install all optical transceivers and connect all optical fibers.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
217