Huawei USG6000 Series Hardware Manual page 219

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Figure 2-41 Installing a hard disk unit
Step 4 After the installation is complete, perform the following operations:


----End
Installing Two Hard Disk Units
Two hard disk units support RAID 1. After the hard disk units are installed, manually create a
RAID group.
Step 1 Use the previous method of installing one hard disk unit to install hard disk units in the HDD0
and HDD1 slots.
Step 2 After the installation is complete, perform the following operations:


Issue 03 (2015-01-26)
Operations after the USG power-on must be performed after all installation tasks are complete.
Before the USG is powered on, ensure that the hard disk combination is correctly
installed.
After the USG is powered on, run the display disk information command in the user
view to check whether the Filesystem Status value is Mounted.
Operations after the USG power-on must be performed after all installation tasks are complete.
Before the USG is powered on, ensure that the hard disk units are correctly installed.
After the USG is powered on,
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
209