Huawei USG6000 Series Hardware Manual page 222

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Step 3 Remove the temporary labels on the cable and attach new labels 2 cm away from the
connectors.
----End
Follow-up Procedure
Perform the following checks after the installation:


To ensure that the PC can configure, manage, and maintain the USG through the mini USB
console port, install the mini USB drive program on the PC. You can log in to
http://support.EdgeWave.com/enterprise, choose Software > Enterprise Networking >
Security > NGFW > USG6600, click the corresponding software version node, and
download MiniUSB_driver_en.zip to obtain the mini USB drive program and the installation
method.
To log in to the USG CLI after the console cable is connected, configure the serial port
communication software on the PC. Windows XP and Windows 7 are used as examples.

1.
2.
Issue 03 (2015-01-26)
Figure 2-43 Connecting the console cable to the USG
Ensure that the labels attached to both ends of the cable are correct, clear, neat, and
affixed in the same direction.
Ensure that the cable and connectors are free of any damage or breakage and connected
properly and reliably.
Before you plug in/out the USB cable or power on the USG again after you power it off, you must
disable the serial port communication software first. Otherwise, the PC may fail to load the mini USB
drive program, causing the serial port unavailable. If this fault occurs, you need to disable the serial port
communication software, re-plug in the USB cable, and enable the serial port communication software
again.
Windows XP
Start the HyperTerminal (Windows operating system) or other third-party program that
supports serial ports on the PC.
Create a connection, select the serial port, and configure the serial port parameters as
follows:
− Bit per second: 9600
− Data bit: 8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
212