Installing A Hard Disk Combination - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Unified Security Gateway
Hardware Guide

2.3.4 Installing a Hard Disk Combination

This section describes how to install a hard disk combination (SM-HDD-SAS300G-B) for the
first time to avoid hard disk damage.
Context
Tools


Precautions for the use of hard disks




Procedure
Step 1 Loosen screws on the filler panel and remove the filler panel.
Step 2 Hold the two side surfaces of a hard disk unit, push the hard disk combination into the slot
along the guide rails until it is well seated into the slot, and fasten screws on the two sides of
the hard disk unit.
Issue 03 (2015-01-26)
Phillips screwdriver
ESD wrist strap
Use EdgeWave hard disks. The system cannot recognize the hard disks provided by other
vendors.
The hard disk card does not support hot swap. Therefore, you must install a hard disk
combination before powering on the USG.
Wear an ESD wrist strap to protect the USG and hard disks from electrostatic damage.
Hold the two side surfaces of a hard disk, do not touch the PCB board or squeeze the hard
disk, and do not vibrate, bump, or stack hard disks.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Installation
187