Service And Maintenance For Components, Blocksize Format; Replacing Hardware Components; Replacing The Fan Cu310-2 Dp And Cu310-2 Pn - Siemens SINAMICS S120 Equipment Manual

Service and maintenance

12.2 Service and maintenance for components, Blocksize format

12.2 Service and maintenance for components, Blocksize format
12.2.1

Replacing hardware components

The following components can be replaced with replacement components with the same
Article No.:
● Power Modules
● DRIVE-CLiQ components
● Control Units
12.2.2

Replacing the fan CU310-2 DP and CU310-2 PN

The fan is located on the lower side of the CU310-2. It switches itself on according to the
internal temperature in the unit.
If the internal temperature of the CU310-2 exceeds the permissible limit value, a category
"CU" warning message signaling a Control Unit overtemperature will be output.
In this event, check for the following:
1. Is the cabinet temperature within the permitted range?
2. Is natural convection possible?
3. Is the fan blocked by dirt or foreign bodies?
4. Can the fan rotate freely?
The warning message will be cleared as soon as the fault is rectified and the temperature
falls below the permissible limit.
Note
If the fan does not rotate and all the sources of the fault (items 1 to 4) can be excluded, then
the fan is faulty and must be replaced.
396
Manual, 06/2019, 6SL3097-5AL00-0BP1
AC Drive