Hardware User Guide
Setting Up The Cable
Download Cable Schematic
1-22
If you are using the Hardware Debugger Software and a PC as a host
system, manually select your cable as follows.
Output > Cable Setup
Select your cable type, then click OK. If you are using the XChecker
cable, you may also select a BAUD rate. See
If you are using the JTAG Programmer software, select the cable
manually as follows.
Output > Cable Auto Connect
Select your cable type, then click OK.
The following figure is an internal schematic of the Parallel Cable III.
You must use the recommended lengths for parallel cables. Xilinx
cables are typically six feet (approximately two meters) in length
between the connector and active circuitry. Keep the wires between
the headers and target system as short as possible.
Table
1-4.
Xilinx Development System