Parameter Setting - Mitsubishi Electric MELSEC Q Series User Manual

6.3

Parameter Setting

Set positioning parameters and OPR parameters.
Setting parameters on the screen omits the parameter setting in a sequence program.
(1) Setting method
Open the "Parameter" window.
1.
Start "Parameter" in the project window.
Project window
2.
Double-click the item to change the setting, and input the setting value.
• Items to input from the pull-down list
For "Positioning mode", double-click the item to display the pull-down list. Select an option.
• Items to input from the text box
Double-click the item to set, and input the setting value.
For details on setting values, refer to the following.
Fixed parameter
Variable parameter
OPR parameter
108
[Intelligent Function Module]
Setting item
Stroke limit upper limit
Stroke limit lower limit
Numerator of command pulse
multiplication for electronic gear
Denominator of command pulse
multiplication for electronic gear
Speed limit value
Acceleration time
Deceleration time
In-position range
Positioning mode
OP address
OPR speed
Creep speed
Setting for the movement amount after
near-point dog ON
Module name [Parameter]
Default value
2147483647 pulse
0 pulse
1
1
200000 pulse/s
300 ms
300 ms
5 pulse
0: Position control mode
0 pulse
10000 pulse/s
1000 pulse/s
75 pulse
Reference
Page 76, Section 5.2 (1)
Page 77, Section 5.2 (2)
Page 77, Section 5.2 (3)
Page 78, Section 5.2 (4)
Page 78, Section 5.2 (5)
Page 78, Section 5.2 (6)
Page 79, Section 5.3 (1)
Page 79, Section 5.3 (2)
Page 80, Section 5.3 (3)
Page 81, Section 5.3 (4)