Mitsubishi Electric FR-E700EX Instruction Manual page 189

(1) Operation mode basics
 The operation mode specifies the source of the start command and the speed command for the drive unit.
 Basically, there are following operation modes.
 External operation mode: For inputting start command and speed command with an external potentiometer and switches
which are connected to the control circuit terminal.
 PU operation mode: For inputting start command and speed command with the operation panel or parameter unit (FR-PU07).
 Network operation mode (NET operation mode): For inputting start command and speed command with RS-485
communication through PU connector or communication option.
 The operation mode can be selected from the operation panel or with the communication instruction code.
GOT
Programmable controller
REMARKS
 The PU operation mode is not available under position control.
 Either "3" or "4" may be set to select the PU/External combined mode.
 The stop function (PU stop selection) activated by pressing
even in other than the PU operation mode in the initial setting.
(Pr.75 Reset selection/disconnected PU detection/PU stop selection Refer to page 178)
(2) Operation mode switching method
When "0 or 1" is set in Pr.340
Switching through the network
Switch to External
operation mode through
the network.
Network operation
When "10" is set in Pr.340
Network operation
REMARKS
 Refer to the following for switching by the external terminal.
PU operation external interlock signal (X12)
PU-external operation switch-over signal (X16)
External-NET operation switchover signal (X65), NET-PU operation switchover signal (X66)
Pr.340 Communication startup mode selection
Selection of operation mode and operation location
PU operation mode
FR-PU07
Network
operation mode
Personal computer
External operation
Switch to Network operation
mode through the network.
Press on the PU on light
Press on the PU on light
Refer to page 191
Refer to page 192
Refer to page 194
Drive unit
PU operation mode
Operation panel
PU connector
Communication
option card
Control terminal
External
operation mode
of the operation panel and parameter unit (FR-PU07) is valid
Switching with the PU
Press on
the PU to light
Refer to page 192
5 6
4
3 7
2
8
1
9
10
Potentiometer
Switch
Press on
the PU to light
PU operation
PU operation
187
4