Mitsubishi Electric FR-E700EX Instruction Manual page 126

Speed setting by external terminals
REMARKS
During Jog operation or PID control operation, the remote setting function is invalid.
Setting speed is "0"
 Even when the remotely-set speed
is cleared by turning ON the RL
(clear) signal after turn OFF (ON)
of both the RH and RM signals, the
drive unit operates at the remotely-
set speed stored in the last
operation if power is reapplied
before one minute has elapsed
since turn OFF (ON) of both the RH
and RM signals
 When the remotely-set speed is
cleared by turning ON the RL
(clear) signal after turn OFF (ON)
of both the RH and RM signals, the
drive unit operates at the speed in
the remotely-set speed cleared
state if power is reapplied after one
minute has elapsed since turn OFF
(ON) of both the RH and RM
signals.
When selecting this function, re-set the maximum speed according to the machine.
Parameters referred to
Pr.1 Maximum setting
Pr.7 Acceleration time, Pr.8 Deceleration time, Pr.44 Second acceleration/deceleration time, Pr.45 Second deceleration time
Pr.178 to Pr.184 (input terminal function selection)
124
Acceleration (RH)
Deceleration (RM) OFF
Forward rotation (STF)
Power supply
Acceleration (RH)
Deceleration (RM) OFF
Clear (RL)
Forward rotation (STF)
Power supply
CAUTION
Refer to page 115
Refer to page 138
Remotely-set speed stored last time
Within 1 minute
ON
Clear (RL)
ON
ON
Remotely-set speed
stored last time
More than 1 minute
ON
ON
ON
Remotely-set speed
stored last time
Time
ON
ON
ON
1 minute
Operation is performed
at the set speed 0r/min.
Time
ON
ON
ON
Refer to page 125